Netopia 2200 Manual de usuario Pagina 144

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 351
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 143
144
Stateful Inspection Options
Stateful Inspection Parameters are active on a WAN interface only if you enable them on
your Gateway.
Stateful Inspection: To enable stateful inspection on this WAN interface, check the
checkbox.
Default Mapping to Router: This is disabled by default. This option will allow the
router to respond to traffic received on this inter face, for example, ICMP Echo requests.
NOTE:
If Stateful Inspection is enabled on a WAN interface Default Mapping to
Router must be enabled to allow inbound VPN terminations to the router.
TCP Sequence Number Difference: Enter a value in this field. This value represents
the maximum sequence number difference allowed between subsequent TCP packets.
If this number is exceeded, the packet is dropped. The acceptable range is 0 – 65535.
A value of 0 (zero) disables this check.
Deny Fragments: To enable this option, which causes the router to discard fragmented
packets on this interface, check the checkbox.
Vista de pagina 143
1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 350 351

Comentarios a estos manuales

Sin comentarios